An Experimental Study of the Effects of Coolant Fluid on Surface Roughness in Turning Operation for Brass Alloy
Main Article Content
Abstract
The effect of different cutting fluids on surface roughness of brass alloy workpiece during turning operation was carried out in this research. This was performed with different cutting speed, while other cutting parameters had been regarded as constants(feeding rate , and depth of cut). Surface roughness of machined parts that will be tested by electronic surface roughness tester .The results show that the standard coolant gives the best values of surface roughness for fixed cutting speed ,followed by sun flower oil that has approximately the same effect, while the air stream as a coolant gave unsatisfied results for the evaluation of surface roughness.
In the other hand the best values of surface roughness were recorded for maximum cutting speed with all other types of cutting fluids.
Article Details
Section
How to Cite
References
Ahmad dziauddin bin Mohamed, 2010, Effect of Process Parameters on Surface Roughness Produced by Turning Boring Operation Aproject Report Submitted in Partial Fulfillment of The Requirement for the Award of Degree of Master of Engineering.
Dr. Mike S.Lou, Dr. Joseph C.Chen & Dr.Caleb M.Li, 1999, Surface Roughness Prediction Technique for CNC End- Milling,volume15, Number 1- November 1998 to January .
LB Abhang and M.Hameedullah, 2010, Experimental Investigation of Minimum Quantity Lubricants in Alloy Steel Turning. International Journal of Engineering Science and Technology Vol.2 (7).
El Baradie, Cutting Fluids, 1996, Part I: Characterisation, Journal of Materials Processing. Technology 56, 786-797
Da Silva, J. Wallbank, 1998, Lubrication and Application Method in Machining, Lubrication and Tribology 50, 149-152.
Mohd Zulhimi bin Rifin, 2010, Effect of Lubrication Condition on Surface Roughness in Turning Operation.
Mohammed T.Hayajneh, Montasser S.Tah At , Joachim Bluhm, 2007,A Study of The Effects of Machining Parameters on the Surface Roughness in the End-Milling process.Volume1,Number 1,Sep.
O.Cakir, A. Yardimeden, T. Ozben, E. Kilickap, 2007, Selection of Cutting Fluids in Machining. processVolume 25 Issue 2 December .
Raviraj Shetty,etal ,2008, Steam as Coolant and Lubricant in Turning of Metal Matrix Composites, journal of Zhejiang, University Science A .
Rohaida binti Mohd, 2008, Effect of Lubrication Condition on Surface Croughness By Using Lathe Machine.
S. Ebbrell, N.H. Woolley, Y.D. Trimidas, D.R. Allanson, W.B. Rowe, 2000, The Effects of Cutting Fluid Application Methods on the Grinding Process, International Journal of Machine Tools and Manufacture. Vol40, 209- 223
Suleiman- Abdulkareem1, Usman Jibrin Rumah1 and Apasi Adaokoma1, 2011, Optimizing Machining Parameters during Turning Process, International Journal of
Integrated Engineering, Vol. 3 No. 1, p. 23-27