PREDICTION OF THE EFFICIENCY OF SIEVE TRAY USING AIRWATER SYSTEM
Main Article Content
Abstract
This investigation deals with the effect of weir height, liquid and gas flow rate on tray efficiency.
The tests were carried out on a single pass cross flow tray of air-water system of 0.3 m diameter for clear
liquid height over sieve tray with weir height 3, 4 and 5 cm.
Point efficiency values were found to be in the same range for different weir height, but it
improves slightly with weir height. And the average values of point efficiency were 83 % for 3 cm weir
height, 85 % for 4 cm weir height and 89 % for 5 cm weir height. While, point efficiency of 90 % was obtained for 5 cm weir height and liquid flow rate ranging between 5.8 to 7.32 m3/s. In the range of clear liquid height over hole diameter ( hL/dH) between 2 to 10, increasing the Reynolds number ranging between 2.0*105 to 1.6*106 for gas phase increases point efficiency. Prediction of Murphree (Tray) efficiency using Lopez and Castells (1999) equation shows that the ratio of EMV/Ep is equal to 1, due to low value of calculated Peclet number (degree of liquid mixing), which ranged between 0.07 to 1.5.
Article Details
How to Cite
Publication Dates
References
. American Institute of Chemical Engineers (1958), “Bubble-tray design manual”, AIChE, New York.
. Bennett, D. L. and Grimm, H. J., “Eddy dffusivity for distillation sieve trays”, AIChE J 37, 4 (1991) 589-596.
. Bennett, D. L. and Kovak, K. W. (2000), “Optimize distillation columns“, AIChE.
. Bennett, D. L., Kovak, K. W. and Zak, D. (1997), “Optimization of sieve type distillation trays“, AIChE Annual Meeting, Los Angeles.
. Bennett, D. L., Watson, and Wiescinski, M. A.(1997), “New correlation for sieve-tray point efficiency, entrainment and section efficiency”, AIChE J., 43(6), p 1,611.
. Chan, H. and Fair, J. R. (1984), “Prediction of point efficiencies on sieve trays”, Ind. Eng. Chem. Process Des. Dev., 23, 4, 814-819.
. Coulson, J. M. and Richardson, J. F. (1985), “Chemical Engineering” Vol.6, 1st ed., Pergamon.
. Dribika, M. M., Bidduiph, M. W. (1986), “Scaling-up distillation efficiency”, AIChE J., 32, 11, 1864-1875.
. Fisher, K. S. and Rochelle, G. T. (2002), "Effect of mixing on efficiencies for reactive tray contactors",AIChE J., 11 (48), 2537.
. Foss, A. S., Graster, J. A. and Pigford, R. L. (1958), "Effect of liquid mixing on the performance of bubble trays", AIChE J., 4(2), 231.
. Gautreaux, M. F. and O’Connell, M. E.(1955), “Effect of length of liquid path on plate efficiency”,Chem. Eng. Prog., 51, 232.
. Gracia, J. and Fair, J. R. (2000), “A fundamental model for prediction of distillation sieve tray efficiency.
Model development and validation”, Ind. Eng. Chem. Res., 39, 1818.
. Klemola, K. T. (1998), “Efficiencies in distillation and reactive distillation”, Acta Poly. Scand., Chem. Tech. Ser., No. 257.
. Lewis, W. K. (1936), “Rectification of binary mixtures: Plate efficiency of bubble cap columns”, Ind. Eng. Chem. 28, 399-402.
. Lo’pez and Castelles (1999), “Influence of tray geometry on scaling up distillation efficiency from laboratory data”, Ind. Eng. Chem. Res. 38, 2747- 2753.
. Ludwig, E. E. (1979), “Applied process design for chemical and petrochemical plants”, Vol.2, 2nd ed., p.109 Gulf Publishing Company.