Effect of a Parked Car Orientation on a Temperature Distribution and Cooling Load Calculation: Experimental Study
Main Article Content
Abstract
When a vehicle is left parked in the sun for an extended period, the gathered heat causes damage to several interiors within the cabin and causes discomfort for people and animals left inside the car. In the present work, the effect of the orientation of a parked white minibus on temperature distribution and cooling load calculation is studied experimentally in an open environment. Two different cases were studied facing south and facing east. For several hours, the temperature inside the car cabin had been monitored and measured at five separate locations. The cooling load calculations are carried out based on the experimental measurements. The results show that the overheating of parked cars always happens as a result of the radiation load especially when a car has a large surface glass area. Also, the ambient load is directly proportional to the ambient temperature, and the total load related directly to radiation load reaches the maximum value of 2358.1 W at 3:00 pm for 1st case and 2118.3 W at 11:00 am for 2nd case which shows an increase of 11.32 %. Thus, these results emphasized the fact that the orientation of the parked car may considerably affect the temperature distribution and the cooling load of the car cabin. Also, the study may be considered an essential step in designing any assisted ventilation or auxiliary air conditioning system that may enhance the car cabin conditions even while the car’s engine was off (parked automobile).
Article Details
Section
How to Cite
References
Abd-Fadeel, W.A., and Hassanein, S.A., 2013. Temperature variations in a parked car exposed to direct sun during hot and dry climates. International Journal of Automobile Engineering Research & Development, 3(1), pp. 75-80.
Al-Kayiem, H.H., Sidik, M.F.B.M., and Munusammy, Y.R., 2010. Study on the thermal accumulation and distribution inside a parked car cabin. American Journal of Applied Sciences, 7(6), pp. 784-789.
Aljubury, I.M.A., Farhan, A.A., and Mussa, M.A., 2015. Experimental study of interior temperature distribution inside parked automobile cabin. Journal of Engineering, 21(3), pp. 1-10.
ASHRAE, 2005. Fundamentals, Inch-Pound Edition. Atlanta, GA: American Society of Heating, Refrigerating and Air-Conditioning. Handbook.
Cengel, Y., Cimbala, J., and Turner, R., 2012. EBOOK: Fundamentals of Thermal-Fluid Sciences (SI units). McGraw Hill.
Chen, S., Du, B., Li, Q., and Xue, D., 2022. The influence of different orientations and ventilation cases on temperature distribution of the car cabin in the hot soak. Case Studies in Thermal Engineering, 39, p. 102401. doi:10.1016/j.csite.2022.102401.
Daanen, H.A., Van De Vliert, E., and Huang, X., 2003. Driving performance in cold, warm, and thermoneutral environments. Applied ergonomics, 34(6), pp. 597-602. doi:10.1016/S0003-6870(03)00055-3.
Ding, X., Zhang, W., Yang, Z., Wang, J., Liu, L., Gao, D., Guo, D., and Xiong, J., 2022. Effect of Open-Window Gaps on the Thermal Environment inside Vehicles Exposed to Solar Radiation. Energies, 15(17), p.6411. doi:10.3390/en15176411.
Engineered Wood Products Association of Australasia. 2018. Facts About Plywood [online]: EWPAA. Available at: https://dokumen.tips/documents/ewpaa-f-a-p-lvl-pngfp-facts-about-plywood-lvl-understanding-the-characteristics.html?page=1 [Accessed 1/11/2022.
Farzaneh, Y., and Tootoonchi, A.A., 2008. Controlling automobile thermal comfort using optimized fuzzy controller. Applied Thermal Engineering, 28(14-15), pp. 1906-1917. doi:10.1016/j.applthermaleng.2007.12.025.
Grundstein, A., Null, J., and Meentemeyer, V., 2011. Weather, geography, and vehicle‐related hyperthermia in children. Geographical Review, 101(3), pp. 353-370. doi: 10.1111/j.1931-0846.2011.00101.
Hasan, A.A., 2020. Suggestion of New Double Layers Car Covers to Reduce the Environment Effect on Car Cabin through Parked Unshaded Area. Al-Rafidain University College for Sciences, (47).
Hou, K., Zhang, L., Xu, X., Yang, F., Chen, B., and Hu, W., 2022. Ambient temperatures associated with increased risk of motor vehicle crashes in New York and Chicago. Science of the total environment, 830, p. 154731. doi:10.1016/j.scitotenv.2022.154731.
Joudi, K.A., and Hussien, A.N., 2015. Internal Convective Heat Transfer Effect on Iraqi Building Construction Cooling Load. Journal of Engineering, 21(9), pp. 119-134.
Levinson, R., Pan, H., Ban-Weiss, G., Rosado, P., Paolini, R., and Akbari, H., 2011. Potential benefits of solar reflective car shells: Cooler cabins, fuel savings and emission reductions. Applied Energy, 88(12), pp. 4343-4357. doi:10.1016/j.apenergy.2011.05.006.
Lv, Y., Huang, A., Yang, J., Xu, J., and Yang, R., 2021. Improving cabin thermal environment of parked vehicles under direct sunlight using a daytime radiative cooling cover. Applied Thermal Engineering, 190, p. 116776. doi:10.1016/j.applthermaleng.2021.116776.
Marcos, D., Pino, F.J., Bordons, C., and Guerra, J.J., 2014. The development and validation of a thermal model for the cabin of a vehicle. Applied Thermal Engineering, 66(1-2), pp. 646-656. doi:10.1016/j.applthermaleng.2014.02.054.
McLaren, C., Null, J., and Quinn, J., 2005. Heat stress from enclosed vehicles: moderate ambient temperatures cause significant temperature rise in enclosed vehicles. Pediatrics, 116(1), pp. e109-e112. doi:10.1542/peds.2004-2368.
Melih Akyol, S., and Kilic, M., 2010. Dynamic simulation of HVAC system thermal loads in an automobile compartment. International journal of vehicle design, 52(1-4), pp. 177-198. doi:10.1504/IJVD.2010.029643.
Mezrhab, A., and Bouzidi, M., 2006. Computation of thermal comfort inside a passenger car compartment. Applied thermal engineering, 26(14-15), pp. 1697-1704. doi:10.1016/j.applthermaleng.2005.11.008.
Qawasmi, A., and Taradeh, N., 2017. Smart automobile air conditioning and ventilation system.
Regnier, C., 2013. Guide to setting thermal comfort criteria and minimizing energy use in delivering thermal comfort.
Ružić, D., and Časnji, F., 2012. Thermal interaction between a human body and a vehicle cabin. Heat Transfer Phenomena and Applications, Rijeka: InTech, pp. 295-318. doi:10.5772/51860.
Setiyo, M., Waluyo, B., Widodo, N., Rochman, M.L., Munahar, S., and Fatmaryanti, S.D., 2021. Cooling effect and heat index (HI) assessment on car cabin cooler powered by solar panel in parked car. Case Studies in Thermal Engineering, 28, p. 101386. doi:10.1016/j.csite.2021.101386.
Shireesha, Y., Karthik, S., and Ch Mohan, L.V.N., 2015. Comparison of Different Car Cooling Systems with Portable Car Cooling System. IOSR Journal of Mechanical and Civil Engineering Ver. V. doi:10.9790/1684-12255057.
Simion, M., Socaciu, L., and Unguresan, P., 2016. Factors which influence the thermal comfort inside of vehicles. Energy Procedia, 85, pp. 472-480. doi:10.1016/j.egypro.2015.12.229.
Slavinec, M., Repnik, R., and Klemenčič, E., 2016. The impact of moisture on thermal conductivity of fabrics. Anali Pazu, 6(1-2), pp. 8-12. doi:10.18690/analipazu.6.1-2.8-12.2016.
Torregrosa-Jaime, B., Bjurling, F., Corberán, J.M., Di Sciullo, F., and Payá, J., 2015. Transient thermal model of a vehicle's cabin validated under variable ambient conditions. Applied Thermal Engineering, 75, pp. 45-53. doi:10.1016/j.applthermaleng.2014.05.074.
Zhang, S., He, W., Chen, D., Chu, J., Fan, H., and Duan, X., 2019. Thermal comfort analysis based on PMV/PPD in cabins of manned submersibles. Building and Environment, 148, pp. 668-676. doi:10.1016/j.buildenv.2018.10.033.
Zheng, Y., Mark, B., and Youmans, H., 2011. A simple method to calculate vehicle heat load (No. 2011-01-0127). SAE Technical Paper. doi:0.4271/2011-01-0127.
Zhou, X., Lai, D., and Chen, Q., 2019. Experimental investigation of thermal comfort in a passenger car under driving conditions. Building and Environment, 149, pp. 109-119. doi:10.1016/j.buildenv.2018.12.022.