Prediction of Smear Effect on the Bearing Capacity of Driven Piles
Main Article Content
Abstract
This paper deals with prediction the effect of soil remoulding (smear) on the ultimate bearing capacity of driven piles. The proposed method based on detecting the decrease in ultimate bearing capacity of the pile shaft (excluding the share of pile tip) after sliding downward. This was done via conducting an experimental study on three installed R.C piles in a sandy clayey silt soil. The piles were installed so that a gap space is left between its tip and the base of borehole. The piles were tested for ultimate bearing capacity
according to ASTM D1143 in three stages. Between each two stages the pile was jacked inside the borehole until a sliding of about 200mm is achieved to simulate the soil remoulding due to actual pile driving. The results of the tests exhibited that the pile might loss 14% of its ultimate capacity when it is loaded immediately after installation. Also, it was concluded that the pile may regain of about 9% of its original capacity after 30days of its installation.
Article Details
Section
How to Cite
References
ACI Committee 211, 2008, "Standard Practice for Selecting Proportions for Normal, Heavyweight, and Mass Concrete." (211.1-91), American Concrete Institute, Detroit.
ASTM D1143-81 (reapproved 1994), "Standard Test Method for Piles under Static Axial Comressive Load", Annual Book of ASTM
Standards, Vol. 04.08, New York, USA.
Basu, D., Salgado, R., Prezzi, M., Lee, J. and Paik, K., "Recent Advances in the Design oa AxiallyLoaded Piles in Sandy Soils", 2005, Advances in Deep Foundation, ASCE, (Downloaded from the site www. ascelibrary.org).
D'Appolonia, D.J. and Lambe, T. W., 1971, "Performance of Four Foundations on End-Bearing Piles", Soil Mechanics and Foundation Engineering Journal, ASCE, Vol. 97 SM10, pp. 77-93.
de Mello, V.F., 1969, "Foundation of Buildings on Clay.", Proceeding of 7th International Conference in Soil Mechanics and Foundation Engineering, Mexico City, pp. 49-136
Head, K.H., 2006, "Soil Laboratory Testing", Volumes 1, 2 and 3, 3rd Edition, Whittles Publishing, Scotland, U.K.
Kishida, H., 1967, "Ultimate Bearing Capacity of Piles Driven into Loose Sand.", Soils and Foundations, Vol.7 No.3,pp. 20-29
Lee, J. H. Salgado, R. and Paik, K. (2003), "Estimation of the Load Capacity of Pipe Pile in Sand Based on Cone Penetration Test Results.",
Journal of Geotechnical and Geoenviromental Engineering., ASCE, Vol. 127 pp. 3-16.
Paik, K. and Salgado, R., "Effect of pile Installation Method on Pipe Pile behavior in Sands", Geotechnical Testing Journal (GTJ), Vol. 27, Issue 1 (January 2004).
Poulos, H.G. and Davis, E.H., "Pile Foundation Analysis and Design.", 1980, Rainbow-Bridge Book Co.
Weltman, A. and Little, J., "A Review of Bearing Pile Types" Directorate of Civil Engineering Services (DOE) and Construction Industry Research abd Information (CIRIA) Report PG1, 1977 London.