Surface Free Energy for the Evaluation of Asphalt Binder Stripping
محتوى المقالة الرئيسي
الملخص
Stripping is one of the major distresses within asphalt concrete pavements caused due to penetration of water within the interface of asphalt-aggregate matrix. In this work, one grade of asphalt cement (40-50) was mixed with variable percentages of three types of additives (fly ash, fumed silica, and phosphogypsum) to obtained an modified asphalt cement to resist the effect of stripping phenomena .The specimens have been tested for physical properties according to AASHTO. The surface free energy has been measured by using two methods namely, the wilhelmy technique and the Sessile drop method according to NCHRP-104
procedures. Samples of asphalt concrete using different asphalt cement and modified asphalt cement percentages(4.1,4.6 and 5.6) were prepared and tested for stripping phenomena by using Marshall Immersion method (The index of retained stability test(I.R.S) ≥75 %. When using Sessile drop method the value of surface free energy of asphalt cement grade (40-50) was about 8.8 ergs/cm2
, while when using Wilhelmy technique the value of surface free energy of asphalt cement was 30.71 ergs/cm2. Finally, a mathematical relationship was obtained by using (SPSS) Software between the strippingasphalt concrete using conditioned and unconditioned specimens data (I.R.S) %, the contact angle, the total surface free energy for asphalt cement and modified asphalt cement with fume silica.
تفاصيل المقالة
القسم
كيفية الاقتباس
المراجع
• Arabani, M. and Hamedi, Gh.(2010). “Using the Surface Free Energy Method to Evaluate the Effects of Polymeric Aggregate Treatment on Moisture Damage in Hot Mix Asphalt” (ASCE), volume No.23, pp. (802-811).
• Bhasin, A.; Little, D., Vasconcelos, K. and Masad, E. (2007). “Surface Free Energy to Identify Moisture Sensitivity of Materials for Asphalt Mixes”,(TRB), volume 2001, pp. (37-45).
• Cheng, D.; Little, D.; Lytton, R.; and Holste, J. (2002) “ Surface Free Energy Measurement of Aggregates and Its Application to Adhesion and Moisture Damage of Asphalt aggregate Systems”AAPT, Vol.71, pp.( 59-88).
• Little, D. and Bhasin, A. (2006). “Using Surface Energy Measurements to Select Materials for Asphalt Pavement”, Final Report for National Cooperative Highway Research program NCHRP Project 9-37(W104).
• State Commission of Roads and Bridge (SCRB) (2003): " Hot Mix Asphalt Concrete Pavement", Iraq Standard Specification, Ministry of Housing and Construction, Department of Design and Study ,Section R9.
• Shah, B. (2003). “Evaluation of Moisture Damage within Asphalt Concrete Mixes”, M.Sc Thesis, Texas A&M University.
• Wasiuddin, N. (2007). “Effect of Additives on Surface Free Energy Characteristics of Aggregates and Binders in Hot Mix Asphalt”, the Texas Transportation Institute (TTI).
• Yousif, S., (2003), “Improving Bituminous Material Properties to Reduce the Effect of Stripping” M.Sc thesis, University of Technology/Baghdad.
• Zhou, L.; Chen, F.; Jiang, Y.; and Qi Xie.(2009).“ Influence of Water Saturated State on Moisture Susceptibility of Asphalt Mixture”,ASCE Performance Modeling and Evaluation of Pavement Systems and Materials (GSP 195) Proceedings of Selected Papers from the 2009, No.354,issue No.16.