BEARING CAPACITY OF SHALLOW FOOTING ON SOFT CLAY IMPROVED BY COMPACTED CEMENT DUST
Main Article Content
Abstract
Low bearing capacity of weak soil under shallow footings represents one of construction problems. Kaolin with water content converges to liquid limit used to represent the weak soil under shallow footing prototype. On the other hand, cement dust, which can be defined as undesirable industrial waste material come from cement industry, was used to improve the bearing capacity of the soft soil considered in this research. The soft soil was prepared in steel box (36×36×25) cm and shallow square footing prototype (6×6) cm were used .Group of physical and chemical tests were conducted on kaolin and cement dust. The improvement were performed by making trench under the footing filled with compacted cement dust (at its optimum moisture content) at three depths (D=B, D=2B, D=3B), the trench had the same footing Dimensions, note that (B) represent the footing width. Pressure-settlement curves were used to predict the ultimate bearing capacity. The improvement ratio in bearing capacity was calculated by comparing the ultimate bearing capacity value when testing the kaolin alone with its value of kaolin improved with compacted cement dust at the same value of eccentricity. It is important to note that eccentricity values were chosen according to the rule of middle third of footing base(i.e.,e≤B/6). The improvement ratio was about (197%) in average value, that represent a good ratio of improvement.
Article Details
How to Cite
Publication Dates
References
ASTM D854-02 Standard Test Methods for Specific Gravity of Soil Solids by Water Pycnometer.
ASTM D698-00 a Standard Test Methods for Laboratory Compaction Characteristics of Soil Using Standard Effort (12,400 ft-lbf/ft3 (600 kN-m/m3)).
ASTM D1194-94 Standard Test Method for Bearing Capacity of Soil for Static Load and Spread footings.
ASTM D2166-80 Standard Test Method for Unconfined compression Test of Soils.
ASTM D2435-80 Standard Test Method for Standard Consolidation Test of Soils.
ASTM D3080-98 Standard Test Method for Direct Shear Test of Soils under Consolidated Drained Conditions.
ASTM D4318-00 Standard Test Methods for Liquid Limit, Plastic Limit, and Plasticity Index of soils.
Chakrabrti and Bhandri,(2004), “Improvement of Settlement Behavoir and Vertical Dispersion of Soft Clay Using Compacted Pulverised Fuel Ash”, Department of Civil engineering , Both at Jadavpur University, Kolkata 700 032. IE(I) Journal- CV, Vol 84, February
Das B.M. and Hanna A.M,(1988),"Model tests for shallow strip foundation on granular trench" (GSP 16), ED BM Das, ASCE, New York,.110-124.
Deschamps, R.J. (1998), “ Using FBC and Stoker Ashes as Roadway Fill: A Case Study”. Journal of Geotechnical and Geoenviromental Engineering. Vol.124, No.11 /November.
Khadhair, A.A. (1997), “Stabilization of Nasriyia Sand Dunes by Cement Dust ”, M.SC. Thesis, Buildings and Construction Department, College of Engineering, University of Technology,Baghdad.
Vesic A.S., (1973),"Analysis of Ultimate loads of Shallow Foundations", J. soil Mech. Found. Div. (ASCE), 99(1), 45-73.